Free Shipping*Lower 48. Orders over $100.
Over 10,000 PartsIn Stock & Ready to Ship.
How-To VideosOver 60+ videos and counting.
Expert Support5-Star Rating!
Dimple dies are used in sheet metal and off road fabrication. A dimple died piece of sheet metal is stronger and lighter than the same piece of metal without the dimple die. By drilling an appropriate hole in the metal and then pressing the metal plate with a die set you give the panel rigidity.
Dimple died panels are used throughout all race cars, not just off road buggies and sand rails. They can be used to gusset a roll cage to the vehicle body or when fabricating a new roof rack, bumper or side bars. We offer dimple dies for 0.5, 0.75, 1.0, 1.25, 1.5, 2.0 and 2.5 inch holes.
California Pacific / JBugs.
All rights reserved. All images protected by US and International copyright laws. No part of this website may be reproduced, distributed, or transmitted in any form or by any means. All Prices subject to change without notice or obligation. Not responsible for typographical or photo errors. "Volkswagen", "VW","Beetle", "Super Beetle", "Bus", "Ghia", "Type 2", "Type 3", "Thing", "Rabbit", "Cabriolet", "Jetta", and "Golf" are trademarked by Volkswagen of America and are used for descriptive purposes only.