EMPI's stock height shocks for Type 1 models with link pin front ends and are sold individually. This
oil-filled shock is 10 1/2" long in the fully closed position and 16 1/4" at full open. The shock fits 1954 to 1965 Standard Beetle
and 1956 to 1965 Karmann Ghia models as a front shock(with link pin front end) and all Type 1 & 3 models as a rear shock. Stock
height shocks also fit vehicles with drop spindles, but perform poorly with any more than a 2-3" drop.
Shock Absorber Fitment: Front
The eyelets at the upper and lower ends of the shock have a 12mm (just under 1/2") inner diameter sleeve. The mount on the trailing
arm should measure about 11.9mm (just over 7/16").If the hole is "too small" to fit on the lower mount, then the old shock sleeve
has rusted in place and must be removed. Sometimes a pair of vice grips is all it takes, sometimes heat, a chisel or even a cut off
wheel have been needed.
Stock Height - Stock Shock
Lowered with Drop Spindles - Stock Shock
Lowered more than 3 inches with Adjustable Beam - Lowered Shock Rear
The stock length rear shock absorber will work for nearly all lowered rear applications.
EMPI recently changed suppliers for their shock absorbers and these shocks may come painted white, or red. Either way it will still be the correct, oil filled shock absorber.
California Prop 65 Warning:
Please Note:The information listed below is for stock, unmodified VW's manufactured for sale in the US. VW's are commonly modified and very often parts from another year VW may have been installed on your car. California Pacific JBugs is not responsible for any errors if your car has been modified in any way.
When installing a new shock absorber on the front of your VW, make sure that the old shock sleeve is removed. The bolt that the shock absorber bolts to IS NOT a shouldered bolt. The shaft of the bolt has roughly the same outer diameter of the threaded area. If the old shock sleeve is rusted in place, use a pair of vice grips to break it free and remove it.